TM 1-1520-265-234.26.3.6. Inspection Procedure. Refer to Eddy Current Method, paragraph 1.4.11 and Figure 4-26.a.Place probe on a good area in the inspection location and null. Adjust phase as required to obtain horizontal lift-off.b.Inspect the part.c.Any signal similar to the notches in the test block are cause for rejection.NOTEEither probe identified in paragraph 4.26.3.1 may be used depending primarily on the ease ofaccessibility and user friendliness. If the probes are changed, steps 4.26.3.5 b. (1), (2), and (3)shall be repeated each time a change is made.4.26.3.7. Marking and Recording of Inspection Results. Mark and record inspection results as required by paragraph1.3.4.26.4. BackupMethod. Fluorescent Penetrant, refer to paragraph 1.4.7.4.26.5. SystemSecuring. The wheel requires assembly and installation in accordance with the applicable technicalmanuals listed in Table 1-1.Figure 4-26. Main Landing Gear Wheel Assembly4-63
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business