TM 1-1520-265-23
Table 1-7. Equipment Used for NDI
Fluorescent Penetrant
Fluorescent Penetrant Inspection Kit
Method
Black Light UV Kit
Black Light Meter
Black Light Bulbs
Filter UV
Magnetic Particle Method
Yoke and Coil Kit
Black Light
Magnetic Particle Inspection Probe
Magnetometer
Eddy Current Method
Eddy Current Inspection Unit
Cable Assembly, Coaxial 6-feet long (1 required)
Reference Block Aluminum (0.008, 0.020, and 0.040
EDM notches)
Reference Block Titanium (0.008, 0.020, and 0.040
EDM notches)
Reference Block Magnesium (0.008, 0.020, and
0.040 EDM notches)
Reference Block - Block of Six Conductivity
Samples
Probe, straight, shielded surface 100 KHz-500
KHz
Probe, right angle, shielded surface 100 KHz-500
KHz, 90° 1/2 inch drop
Ultrasonic Method
Ultrasonic Inspection Unit
Cable Assembly, BNC to microdot
Transducer 5 MHz 45°S Shear 1/4 x 1/4
Bond Testing Method
Bond Test Inspection Unit
Cable Assembly
Probe, Mechanical Impedance Analysis
Probe Holder, spring loaded
Test Block, Composite Defect Standard #1
Test Block, Composite Defect Standard #3
Test Block, Aluminum Honeycomb with 0.020 inch
thick aluminum /honeycomb skin (refer to Appendix C)
Test Block, Aluminum Honeycomb with 0.040 inch
thick aluminum skin (refer to Appendix C)
Test Block, Aluminum Honeycomb with 0.063 inch
thick aluminum skin (refer to Appendix C)
Radiographic Method
Tripod X-Ray Tubehead Stand
Signal Appliance Lamp Assembly
X-Ray Unit (LPX-160 Water Cooled Digital)
Film Processor
NOTE: Refer to Appendix B for equipment part number, national stock number, and manufacturer.
1-38
