0012 00TM 1-6625-724-13&P0012 00-125.Current Units. This block provides a table of the current selected display units. Display units can be modifiedfrom the Manager Menu Setup option.6.Required Installation. This section provides basic setup information for the aircraft type currently selected. Itincludes the UTD installation angle and the type of accelerometer selected for each of the channels.d.Selecting SetupThe Setup Menu contains all the operations to change the current system's setups, see figure 5. The following isa description of those operations:1.Printer OptionsThe AVA contains a print spooler that is capable of storing up to twenty selected screen images and sendingthem to the printer. The CADU provides both parallel and serial interfaces for printers. The serial interface isused with the AVA printer or a serial printer with Epson graphics. The parallel interface is used with printerscontaining a Centronix parallel interface with Epson graphics. In order to change the number of screenimages that can be stored, refer to ENABLE command. The CADU is designed to control several differentserial interface type printers, such as Epson compatible printers and the AVA printer. Place the cursor overthe Printer selection and press DO. Use the UP and DOWN arrow keys to maneuver through the menuselections described in the following paragraphs.(a) Changing Printer TypesTo change the printer type, position the cursor over the Change Type selection in the Printer ControlMenu, figure 6, and press DO. A list of available printer types will be displayed. Position the cursor overthe desired type and press DO. The new printer type will be installed.(b) Changing Printer PortsTo change the printer port type, position the cursor over the Change Ports selection in the Printer ControlMenu and press DO. A Printer Ports selection menu allows the operator to select either the parallel orserial printer port, which ever is required for the printer being used.(c) Enabling/Disabling Print SpoolerThe print spooler buffers screen images for printing while the printer is not hooked up. Once the printer ishooked up, the screens will be printed out in the order that the screens were spooled to the buffer. Whenthe spooler is enabled, screens are printed. When the spooler is disabled, screens are just buffered inthe CADU’s internal memory. After the CADU is rebooted, the print spooler is returned to the enabledstate. To enable or disable the print spooler, position the cursor over the desired selection in the PrinterControl menu and press DO. It is recommended to leave print spooling enabled.(d) Flushing Print Spooler BufferScreens that have been previously spooled can be deleted, if printing is no longer desired or a userprefers to print new screens rather than old screens. To delete old buffered screens, position the cursorover the Flush Queue selection and press DO.(e) Printer Spooler FailureIn the event of a printer spooler failure, it will be necessary to restart the spooler. To restart the spooler,position the cursor over the Restart Spooler option and press the DO key. This option is only available ifthe printer spooler is not running.2.Setting System Time and Date FunctionThis function allows the current time and date to be changed. To select this function, place the cursor overthe Set Time & Date option and press the DO key. An entry will appear. Use the UP and DOWN arrow keysto move through the selections. Use the HELP key on a chosen selection (highlighted) for specificinformation on that choice. Use the numeric keypad to enter values. In cases where two digit values arerequired (such as the date) use the LEFT and RIGHT arrows keys to position over the appropriate digit to bechanged. To cancel changes, press the QUIT key to exit anytime.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
