TM 1-1520-265-235-28 Change 25.16.3.6 Marking and Recording of Inspection Results. Mark and record inspection results asrequired by paragraph 1.3.5.16.4 BackupMethod. None required.5.16.5 SystemSecuring. Clean the inspected parts to remove inspection media. Refer to PostCleaning and Restoration or Part or Area After NDI, paragraph 1.4.16. The rotary input assemblyrequires assembly and installation in accordance with the applicable technical manuals listed inTable 1-1.5.17 ENGINE LOAD DEMAND CONTROL CABLE SUPPORT (PT).5.17.1 Description(Figure5-1,IndexNo.17). The cable support is mounted on top of thetransmission and secures the engine load-demand push-pull rods.5.17.2 Defects. Defects can occur anywhere on the surface of the support. No cracks are allowed.5.17.3 PrimaryMethod. Fluorescent Penetrant.5.17.3.1 NDI Equipment and Materials. (Refer to Appendix B.) Inspection equipment is listed inTable 1-7. AMS 2644 level 3 penetrant materials shall be selected from the approved list in Table1-8. Parts requiring flourescent penetrant inspection shall be cleaned prior to inspection withn--Propyl Bromide (vapor degreasing only)(Table 1--8), DS--108 (Table 1--8), Electron (Table 1--8),Positron (Table 1--8). DS--108, Electron, Positron must be followed by an acetone (Table 1--8) rinseor wipe: or drying until there is no visible solvent residue left on parts.5.17.3.2 Preparation of Helicopter. The helicopter shall be prepared for safe ground maintenance.A partial inspection for cause (visual indications, sites of mechanical damage, corrosion, etc.) maybe performed on all exposed surfaces of the installed part using this procedure. If required, the cablesupport shall be removed in accordance with the applicable technical manuals listed in Table 1-1.5.17.3.3 Access. Access is obtained through the sliding cover (Figure 1-4, items 3T-4T-2).5.17.3.4 Preparation of Part. Refer to Preparation of Part or Area for NDI, paragraph 1.4.4.5.17.3.5 Inspection Procedure. Perform fluorescent penetrant inspection. Refer to FluorescentPenetrant Method, paragraph 1.4.7 and Table 1-5. Inspect area of concern. See Figure 5-17.5.17.3.6 Marking and Recording of Inspection Results. Mark and record inspection results asrequired by paragraph 1.3.5.17.4 BackupMethod. None required.5.17.5 SystemSecuring. Clean the cable support to remove inspection media. Refer to PostCleaning and Restoration of Part or Area After NDI, paragraph 1.4.16. The cable support, if removed,requires installation in accordance with the applicable technical manuals listed in Table 1-1.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business