TM 1-1520-265-23
2-25
Figure 2-12. Droop Stop Cam
NOTE
Either probe identified in paragraph 2.12.3.1 may be used depending primarily on the
ease of accessibility and user friendliness. If the probes are changed, steps 2.12.3.5
b. (1), (2), and (3) shall be repeated each time a change is made.
2.12.3.7 Marking and Recording of Inspection Results. Mark and record inspection results as
required by paragraph 1.3.
2.12.4 Backup Method. None required.
2.12.5 System Securing. The droop stop cam, if removed, requires installation in accordance with
the applicable technical manuals listed in Table 1-1.
2.13 DAMPER ASSEMBLY (ET).
2.13.1 Description (Figure 2-1, Index No. 13). Dampers are installed between each of the main
four rotor hub and spindle modules to restrain lead and lag motion of the blades during rotation and
to absorb rotor head engagement loads.
2.13.2 Defects. The inspection is used to verify crack indications found visually on the damper
assembly. No cracks are allowed.
2.13.3 Primary Method. Eddy Current.
