0048 00
TM 1-6625-724-13&P
0048 00-2
5. Rotate extractor (8) to loosen acquisition card (9) from back plane connectors (10).
6. Pull acquisition card (9) from card cage (5).
7. Rotate extractor (11) to loosen processor card (12) from back plane connectors (10).
8. Pull processor card (12) from card cage (5).
9. Rotate extractor (13) to loosen power supply card (14) from back plane connectors (10).
10. Pull power supply card (14) from card cage (5).
11. Remove four hex nuts (16), and four lock washers (17) from four positioning bolts (18).
12. Remove front panel assembly (19) from card cage (5).
13. Remove two cable connectors (20 and 21) and two terminal rings (22) from PWA back plane (23).
14. Cut tie wraps and de-solder two wires from the LED assembly (24).
15. Remove adhesive around the LED assembly (24).
16. Pull LED assembly (24) from front panel (19) releasing green cover (25) from front side of front panel (19).
b. INSTALLATION:
1. Install LED assembly (24) into back of front panel (19) at hole (26).
2. Install green cover (25) at the front side of front panel (19). Items will snap together.
3. Apply silicone adhesive (item 2, WP0066 00) around LED assembly (24) to hold assembly in place.
4. On LED assembly (24), solder white wire to J1-1, and red wire to J2 insulated terminal. Secure wires with
tie-wraps (item 10, WP0066 00).
5. Connect two cable connectors (20 and 21) and two terminal rings (22) onto PWA back plane (23).
6. Apply thread-lock adhesive to threaded hardware.
7. Install front panel assembly (19) onto card cage (5) four positioning bolts (18), and attach with four hex nuts
(16), and four lock washers (17).
8. Install acquisition card (9) into card guides (15) pushing card into back plane connectors (10).
9. Install processor card (12) into card guides (15) pushing card into back plane connectors (10).
10. Install power supply card (14) into card guides (15) pushing card into back plane connectors (10).
11. Install PWA hold-down bracket (7) in place in the card cage (5) using two screws (top and bottom (6).
12. Install enclosure (4) onto card cage (5).
13. Install four screws (1), four lock washers (2), and four flat washers (3) through four holes in the enclosure
(4) into the card cage (5).
