OPERATION GRAM/OUNCE SCALE CONT.

SHUTDOWN PROCEDURES AVIATION VIBRATION ANALYZER

TM-1-6625-724-13P Aviation Vibration Analyzer Manual
Page Navigation
80

0013 00 TM 1-6625-724-13&P 0013 00-2 CAUTION Always turn the scale OFF before selecting a display mode of Gram or Ounce. Changing modes while weighing may affect the accuracy of the scale. 2. Select a weighing mode by sliding the Gram/Ounce selector switch to either the Gram or Ounce mode. NOTE Placing an object on the scale top tray prior to an indication of "0" (zero) can cause inaccurate measurements. Wait for the scale to indicate "0" before placing objects on the scale top tray. 3. Turn the scale on by pressing the ON/TARE switch on the front panel and wait for a "0" (zero) indication. CAUTION Do not exceed the total capacity of the Gram/Ounce scale (2000 g / 70 oz) when weighing objects or combinations of objects. Exceeding the total capacity of the scale will cause a readout display of "E" and may cause damage to the scale. 4. Place the weight to be measured as near to the center of the top tray as possible. 5. Read the weight of the object on the front panel display. The readout may wander slightly due to the sensitivity that is affected by the slightest vibration or air movement. 6. Press the ON/TARE switch on the front panel to place the scale in the Multiple TARE mode of operation. The display readout will automatically reset to "0" (zero) and a small triangle will appear in the upper left hand corner of the display. CAUTION Do not exceed the total capacity of the Gram/Ounce scale (2000 g / 70 oz) when weighing objects or combinations of objects. Exceeding the total capacity of the scale will cause a readout display of "E" and may cause damage to the scale. 7. Place the next weight on the scale. The readout displays the measurement of the second weight only. 8. Press the ON/TARE switch on the front panel. The readout displays the measurement of both weights, combined. 9. Repeat steps 6 through 8 for additional items to be weighed. If the internal 9-volt battery is weak, the front panel readout will display "LO". When this occurs the battery must be replaced. END OF WORK PACKAGE

Privacy Statement
Press Release
Contact