TM 1-6625-724-13&P0040 000040 00-1CADU HARNESS ASSEMBLYREMOVAL AND INSTALLATIONIndexRemoval............................................................................................................................................................................ 1Installation......................................................................................................................................................................... 1InitialSetup:PersonnelRequired:TMDE Support SpecialistToolsandEquipment:Tool Kit, ElectriciansParts/Materials:Harness PN 29324200, Thread-lock adhesive, Permabond 910EquipmentCondition:CADU power turned off. Lay unit with keypad down on support strips toprotect facing.a. REMOVAL: 1. Remove nine screws (1), nine lock washers (2), and nine flat washers (3) from bottom plate (4).2. Remove bottom plate (4) from top case (5). 3. Disconnect cable connector (6) from J4 on PWA. 4. Remove one standoff (7), one flat washer (8), and ground lug (9). 5. Remove four screws (10) from nut plate (11). 6. Remove cable harness assembly (12) for replacement. 7. Remove gasket (13) from cable harness assembly (12). b. INSTALLATION: 1. Install gasket (13) on cable harness assembly (12). 2. Place new cable harness assembly (12) into top case (5). 3. Place nut plate (11) in place to backup mounting. 4. Apply thread-lock adhesive to threaded hardware. 5. Install four screws (10). 6. Connect cable connector (6) to J4. 7. Install ground lug (9), one flat washer (8), and one standoff (7). 8. Inspect O-ring (14). If replacement is needed, use Permabond 910 to seal O-ring. 9. Install bottom plate (4) in place in top case (5). 10. Install nine washers (3), nine lock washers (2), and nine screws (1).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
