TM 1-6625-724-13&P0073 000073 00-9NOTEOnce the UTD is installed, access to the DC externalpower receptacle is not possible.b. Mount UTD to bracket, ensuring that the night lens (red lens) is below the optical lens (clear lens).Figure 5. Universal Tracking Device (UTD) InstallationWARNINGEnsure UTD cable does not interfere with the CPOpedal travel.c. Connect UTD cable (29325701) to UTD connector. Route cable through the drain hole in CPO chin bubble.Connect cable to the DAU receptacle marked TRACKER 1. Secure cable to chin bubble with reinforced tape(duct tape).d. Ensure that the TRACKER MODE switch on the front of the DAU is in the DAY position.e. Paint the bottoms of all four blades with flat black paint in the area where the UTD views the blades.Reference figure 6.NOTEWhile tracking the rotor without a sunshield is possible, itis recommended that the operator use sunshield(29722100) when tracking on sunny days. The use ofthe sun shield will result in fewer tracker errors.PROCEDURE 5: NIGHT-TIME TRACKING INSTRUCTIONSNOTEThe following steps are required prior to performing nighttracking. If no flights will be performed after dusk,proceed directly to task 2.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
