0073 00
TM 1-6625-724-13&P
0073 00-10
a. Ensure that the TRACKER MODE switch on the front of the DAU is in the NIGHT position.
b. Ensure that the underside, trailing edge of all blades is as clean as possible. This is necessary for optimum
adhesion of the reflective tape.
NOTE
The placement of the tape can be verified by holding a
flashlight near your head and shining it at the rotating
blades. Any misplaced sections of the tape will stand
out.
c. Attach a single, 3-ft section of reflective tape on the underside, trailing edge of each blade as shown in figure
6. Ensure that the tape is smooth and as straight as possible using the edge of the blade as a reference.
d. Remove sunshield if installed.
Figure 6. Placement of Reflective Tape on Rotor Blades