0072 00
TM 1-6625-724-13&P
0072 00-8
c. Place a single, 3-ft section of reflective tape on the underside, trailing edge of each blade as shown on figure 5.
Ensure that the tape is smooth and as straight as possible using the edge of the blade as a reference.
d. If verification of the tape placement is desired, it can be viewed by holding a flashlight near your head and
shining it at the rotating blades. Any misplaced sections of the tape will stand out.
Figure 6. Placement of Reflective Tape on Rotor Blades
NOTE
Remove the reflective tape when the procedure is
complete.
