0035 00
TM 1-6625-724-13&P
0035 00-2
5. Remove three screws (8), three lock washers (9), and three flat washers (10) from PWA edge adjacent to
battery pack.
6. Remove six standoffs (11), six flat washers (12), and ground lug (13).
7. Remove four lock screw assemblies (14).
8. Stand PWA (16) on end to the extent allowed by keypad connectors (17) and (18).
9. Remove gasket (15).
10. Remove two hex nuts (19), two lock washers (20), and two flat washers (21).
11. Remove battery pack (22) with two clamps (23).
b. INSTALLATION:
1. Install two mounting clamps (23) on battery pack (22).
2. Apply thread-lock adhesive to threaded hardware. Position mounting clamps (23) on two mounting studs
(24).
3. Install two flat washers (21), two lock washers (20), and two hex nuts (19).
4. Stand PWA (16) on end to gain access to clean the lens (25) and display face.
5. Clean lens as follows:
(a) Wipe display face with a lint-free pad containing special lens cleaner.
(b) Wipe dry with a lint-free cloth and dry-forced air.
(c) Repeat steps (a) and (b) to clean the lens (25) and lens gasket (26).
(d) Install gasket (15).
(e) Put PWA (16) in place and inspect lens surface from operators side of CADU.
(f) If lint or smudges are still present, repeat steps (a) through (e).
6. Install four lock screw assemblies (14).
7. Install six standoffs (11), six flat washers (12), and ground lug (13).
8. Install three screws (8), three lock washers (9), and three flat washers (10) on PWA edge adjacent to
battery pack.
9. Connect battery pack cable connector (6) to J6 on the PWA.
10. Connect cable connector (7) to J4 on the PWA.
11. Inspect O-ring (27). If replacement is needed, use Permabond 910 (item 3 WP0066 00) to seal O-ring.
12. Place bottom plate (4) in place in top case (5).
13. Install nine screws (1), nine lock washers (2), and nine flat washers (3).