0036 00
TM 1-6625-724-13&P
0036 00-2
4. Disconnect cable connector (7) from J4 on the PWA.
5. Remove three screws (8), three lock washers (9), and three flat washers (10) from PWA edge adjacent to
battery pack.
6. Remove six standoffs (11), six flat washers (12), and ground lug (13).
7. Remove four lock screw assemblies (14).
8. Lift PWA (16) and disconnect keypad connectors (17) from J10 and (18) from J7 on the PWA.
9. Remove gasket (15).
b. INSTALLATION:
1. Apply thread-lock adhesive to threaded hardware.
2. Connect two keypad connectors (17) to J10 and (18) to J7 on the PWA.
3. Stand PWA (16) on end to gain access to clean the lens (19) and display face.
4. Clean lens as follows:
(a) Wipe display face with a lint-free pad (item 8, WP0066 00) containing special lens cleaner (item 5,
WP0066 00).
(b) Wipe dry with a lint-free cloth (item 7, WP0066 00) and dry-forced air.
(c) Repeat steps (a) and (b) to clean the lens (19) and lens gasket.
(d) Install gasket (15).
(e) Put PWA (16) in place and inspect lens surface from operator's side of CADU.
(f) If lint or smudges are still present, repeat steps (a) through (e).
5. Install four lock screw assemblies (14).
6. Install six standoffs (11), six washers (12), and ground lug (13).
7. Install three washers (10), three lock washers (9), and three screws (8) on PWA edge adjacent to battery
pack.
8. Connect battery pack cable connector (6) to J6 on the PWA.
9. Connect cable connector (7) to J4 on the PWA.
10. Inspect O-ring (21). If replacement is necessary, use Permabond 910 to seal O-ring.
11. Place bottom plate (4) in place in top case (5).
12. Install nine screws (1), nine lock washers (2), and nine washers (3).
