0038 00
TM 1-6625-724-13&P
0038 00-2
3. Disconnect cable connector (7) from J4 on the PWA.
4. Remove three screws (8), three lock washers (9), and three flat washers (10) from PWA edge adjacent to
battery pack.
5. Remove six standoffs (11), six flat washers (12), and ground lug (13).
6. Remove four lock screw assemblies (14).
7. Lift PWA (16) and disconnect keypad connectors (17) from J10 and (18) from J7 on the PWA.
8. Remove gasket (15).
9. Remove lens (19) and lens gasket (20).
10. Clean silicone adhesive from lens cavity (21).
b. INSTALLATION:
1. Apply silicone adhesive (item 2, WP0066 00) to lens cavity (21).
2. Install new lens (19).
3. Peel off backing and install new lens gasket (20).
4. Place PWA (16) into top case (5).
5. Connect two keypad connectors (17) to J10 and (18) to J7 on the PWA.
6. Stand PWA (16) on end to gain access to clean the lens (19) and display face.
7. Clean lens as follows:
(a) Wipe display face with a lint-free pad containing special lens cleaner.
(b) Wipe dry with a lint-free cloth and dry-forced air.
(c) Repeat steps (a) and (b) to clean the lens (19) and lens gasket (20).
(d) Install gasket (15).
(e) Put PWA (16) in place and inspect lens surface from operator's side of CADU.
(f) If lint or smudges are still present, repeat steps (a) through (e).
8. Apply Thread-lock adhesive to threaded hardware.
9. Install four lock screw assemblies (14).
10. Install six standoffs (11), six flat washers (12), and ground lug (13).
11. Install three washers (10), three lock washers (9), and three screws (8) on PWA edge adjacent to battery
pack.
12. Connect battery pack cable connector (6) to J6 on PWA.
13. Connect cable connector (7) to J4 on PWA.
14. Inspect O-ring (29). If replacement is necessary, use Permabond 910 to seal O-ring.
15. Place bottom plate (4) in place in top case (5).
16. Install nine washers (3), nine lock washers (2), and nine screws (1).
