0037 00
TM 1-6625-724-13&P
0037 00-2
4. Disconnect cable connector (7) from J4 on the PWA.
5. Remove three screws (8), three lock washers (9), and three flat washers (10).
6. Remove six standoffs (11), six flat washers (12), and ground lug (13).
7. Remove four lock screw assemblies (14).
8. Lift PWA (16) and disconnect two keypad connectors (17) from J10 and (18) from J7 on the PWA.
9. Remove gasket (15).
10. Remove PWA (16) from top case (5) and turn board over to gain access to the bottom side.
11. Remove four hex nuts (19) and four washers (20).
12. Disconnect cable connector (21) from J1 (22) on the PWA.
13. Remove LCD assembly (23) for replacement.
b. INSTALLATION:
1. Apply thread-lock adhesive (item 1, WP0066 00) to threaded hardware.
2. Place new LCD assembly (23) on mounting studs (24) on PWA (16).
3. Install four hex nuts (19) and flat washers (20).
4. Connect cable connector (21) to J1 (22) on PWA (16).
5. Place PWA (16) into top case (5).
6. Connect two keypad connectors (17) to J10 and (18) to J7 on the PWA.
7. Stand PWA (16) on end to gain access to clean the lens (25) and display face (26).
8. Clean lens as follows:
(a) Wipe display face with a lint-free pad containing special lens cleaner.
(b) Wipe dry with a lint-free cloth and dry-forced air.
(c) Repeat steps (a) and (b) to clean the lens (25) and lens gasket (27).
(d) Install gasket (15).
(e) Put PWA (16) in place and inspect lens surface from operator's side of CADU.
(f) If lint or smudges are still present, repeat steps (a) through (e).
9. Install four lock screw assemblies (14).
10. Install six standoffs (11), six flat washers (12), and ground lug (13).
11. Install three screws (8), three lock washers (9), and three washers (10).
12. Connect battery pack cable connector (6) to J6 on PWA.
13. Connect cable connector (7) to J4 on PWA.
14. Inspect O-ring (28). If replacement is needed, use Permabond 910 (item 3, WP0066 00) to seal O-ring.
15. Place bottom plate (4) in place in top case (5).
16. Install nine screws (1), nine lock washers (2), and nine washers (3).
