0075 00
TM 1-6625-724-13&P
0075 00-10
k. Connect the lateral accelerometer (ACC1) cable to the receptacle on the DAU marked ACC1.
l. Connect the longitudinal accelerometer (ACC3) cable to the receptacle on the DAU marked ACC3.
Figure 7. Combiner Transmission Oil Cooling Fan Accelerometers Installation
CAUTION
When routing cables, ensure that cables are secured
and tied away from rotating assemblies.
PROCEDURE 7: AFT TRANSMISSION OIL COOLING FAN SENSORS INSTALLATION (50 HOUR CHECK
ONLY)
a. Complete procedure 2.
b. Gain access to the AFT transmission oil cooling fan area, see figure 8.
c. Remove the nut from the stud at the 8:30 clock position on the AFT transmission cooling fan flange.
d. Mount an accelerometer mounting bracket (29313000) to the stud with the nut provided and orient the bracket
so that the accelerometer will be lateral when it is installed.
e. Install an accelerometer (28110900), accelerometer 9 (ACC9), on the mounting bracket.
f. Remove the nut from the stud at the 7:30 clock position on the AFT transmission cooling fan flange.
g. Mount an accelerometer mounting bracket (29313000) to the stud with the nut provided and orient the bracket
so that the accelerometer will be vertical when installed.
h. Install an accelerometer (28110900), accelerometer 10 (ACC10), on the mounting bracket.
i. Connect a 50-ft. accelerometer cable assembly (29105600) to each accelerometer.
CAUTION
When routing cables, ensure that the cables are
secured and tied away from rotating assemblies.
j. Identify each accelerometer cable (ACC9 and ACC10) and route forward to the DAU.
