TURN ON/OFF PROCEDURES AVIATION VIBRATION ANALYZER

SELF-TEST PROCEDURE CONT.

Figure 2. DPL Booting Window

TM-1-6625-724-13P Aviation Vibration Analyzer Manual
Page Navigation
34

TM 1-6625-724-13&P 0007 00 0007 00-1 TURN ON/OFF PROCEDURES AVIATION VIBRATION ANALYZER CAUTION The operator must exit DPL prior to performing a system reboot of the AVA to prevent the possible loss or corruption of the internal database data. Figures Figure 1. Start-Up Selection Menu............................................................................................................................. 1 Figure 2. DPL Booting Window.................................................................................................................................. 2 Figure 3. Main Menu .................................................................................................................................................. 2 a. Power On Procedure The CADU is powered from the DAU, the 12 Vdc battery charger, or by its own internal rechargeable battery pack. The internal battery pack is being charged anytime the CADU is connected to external power by the 12 Vdc battery charger or DAU. The CADU can be operated while charging. Power is distributed to the CADU when the DAU power switch is activated. To operate the CADU with or without external power, press the ON key. The CADU will operate eight hours with a fully charged battery, depending on lamp usage. If the CADU does not respond it may be necessary to reboot it, see step b. b. Reboot and Start-Up Selection Menu Note The recommended procedure for rebooting the CADU is a soft reboot, see step 1. If the CADU is locked up a hard reboot is necessary, see step 2. 1. A soft reboot of the CADU is accomplished by simultaneously pressing the DO and QUIT keys. 2. A hard reboot of the CADU is accomplished by first pressing the OFF key. While pressing and holding the HELP key press the ON key. For either case the following message will display after a few seconds: CADU System Bootstrap V3.1 Please Wait... When the above message goes away, the Start-Up Selection Menu will appear (refer to figure 1). ******************************************* *** RADS-AT *** ******************************************* Please select an option: 1: Proceed with normal operation 2: Set up for host communication use this option with the RADSCOM diskette. 3. Load aircraft setup flies from the credit card 4: Modem setup 5: Help menu Select (1, 2, 3, 4, or 5): Figure 1. Start-Up Selection Menu

Privacy Statement
Press Release
Contact