Table 1. Error Reported on CADU Error Screen (cont.)

Table 1. Error Reported on CADU Error Screen (cont.) - TM-1-6625-724-13P_166

Table 1. Error Reported on CADU Error Screen (cont.) - TM-1-6625-724-13P_168

TM-1-6625-724-13P Aviation Vibration Analyzer Manual
Page Navigation
120

TM 1-6625-724-13&P 0025 00 0025 00-29 Table 1. Error Reported on CADU Error Screen (cont.) Code # Message 32367: KERMIT Lost Connection, Please Check Cable and PC, and Try Again The CADU to PC cable is not connected properly. Verify the proper cable is being used and the cable is plugged into the correct PC port. Repeat the backup to PC operation. 32368: KERMIT Failed to Establish Connection, Please Check Cable and PC, and Try Again The CADU to PC cable is not connected properly. Verify the proper cable is being used and the cable is plugged into the correct PC port. Repeat the backup to PC operation. 32453: Unknown Module Failure - Please Report ACTION: (1) Repeat key sequence (2) Reboot CADU Internal software failure. Reboot the CADU. If the failure persists, send unit to TMDE for repair. 32454: CADU Still Setting Up The DAU, Please Wait 10 Seconds And Retry Measurement ACTION: (1) Check CADU to DAU cable (2) Check that DAU's power switch Is on (3) Reboot DAU The DAU, which is currently connected to the CADU, was not started connected to the current CADU. Turn the DAU power off and on, and then repeat the measurement. 32455: Monitor Power Not Running, Try Reboot of CADU ACTION: (1) Retry measurement (2) Check CADU to DAU cable (3) Check that DAU's power switch Is on (4) Reboot CADU The process that starts the DAU is not running properly in the CADU. Reboot the CADU and repeat the measurement. If the failure persists, send unit to TMDE for repair. 32456: Non-module in DAU download directory, CADU wrongly configured 32457: DAU Test Error, Possible Hardware Failure ACTION: (1) Power the DAU off and on (2) Wait 20 seconds, make a measurement The power on self-test has not returned properly. Turn the DAU off and on and repeat the measurement. If the failure persists, send unit to TMDE for repair. 32458: Failed to Set EEPROM date in DAU, Possible Hardware Failure ACTION: (1) Power the DAU off and on (2) Wait 20 seconds, make a measurement The date has not been properly set in the DAU EEPROM. Turn DAU off and on, and then repeat the measurement. If the failure persists, send unit to TMDE for repair. 32468: Insufficient Space to Store Results ACTION: (1) Backup and delete some flight data (2) (not for the Credit Card) After deleting data - run the Manager Menu's compress option 32563: Too Many Adjustments, Best N Can't Optimize More Than 30. Use EDIT Adjustables to add constraints 32564: Invalid Point Range (Low- point % -high-point %) in setup. This limit check Is not possible. ACTION: Check setup defined In aircraft script file AND/OR Reload aircraft script file 32565: Impossible to Calculate Corrections - Please Edit the Adjustments to Add Constraints Not enough data has been collected to run the diagnostics without going to the diagnostics editor and eliminating some adjustments. Either collect more data or go to diagnostics editor. 32566: Failed to Load Enough Data Not enough data is available to run the diagnostics. Acquire the required data, as specified in the Flight Plan.

Privacy Statement
Press Release
Contact