TM 1-6625-724-13&P
0051 00
0051 00-1
UTD PRINTED WIRING ASSEMBLY (PWA)
REMOVAL AND INSTALLATION
CAUTION
This assembly contains parts sensitive to damage
by Electrostatic Discharge (ESD).
Use precautionary ESD procedures when touching,
removing or inserting. Use static-free material to
wrap the assembly for shipment or storage.
Index
Removal............................................................................................................................................................................ 1
Installation......................................................................................................................................................................... 2
Initial Setup:
Personnel Required:
TMDE Support Specialist
Tools and Equipment:
Tool Kit, Electricians
Parts/Materials:
PWA PN 29322500, Thread-lock adhesive, Silicone adhesive
Equipment Condition:
Place UTD on workbench with ESD capability
CAUTION
This assembly contains parts sensitive to damage
by Electrostatic Discharge (ESD).
Use precautionary ESD procedures when touching,
removing or inserting. Use static-free material to
wrap the assembly for shipment or storage.
a. REMOVAL:
1. Remove eight screws (1), eight flat washers (2), eight hex nuts (3), and eight flat washers (4), from base
(5).
2. Using a sharp knife, break seal and remove base (5) with O ring (6) from top body (7).
3. De-solder two connecting wires (8) from terminals (9).
4. Remove two screws (10), two split lock washers (11) and two flat washers (12) from lower section of PWA
(13).
