0053 00
TM 1-6625-724-13&P
0053 00-2
5. Remove three screws (14), three lock washers (15), three flat washers (16) and three nylon spacers (17)
from top section of PWA (13) allowing removal of the PWA.
6. Remove two diode caps (31) from two holes.
7. Disconnect cable connector P1 (18) from bottom side of PWA (13) at J1 (19).
8. Remove infrared filter face cap (20) and O-ring (21).
9. Remove infrared filter (22).
10. Using connector pliers, remove bulb (23).
11. Remove three screws (24), three split lock washers (25) and three flat washers (26) allowing removal of
bulb housing plate mounting (27) from top body (7).
12. Remove two screws (28).
13. Remove bulb socket (29) pulling wires (8) through grommet (30).
b. INSTALLATION:
1. Apply thread-lock adhesive on threads of hardware except step 8.
2. Pass connecting wires (8) of new bulb socket (29) through grommet (30).
3. Install bulb socket (29) with two screws (28).
4. Place bulb housing plate mounting (27) into top body (7).
5. Install three screws (24), three lock washers (25), and three flat washers (26).
6. Install bulb (23) into bulb socket (29).
7. Install infrared filter (22), and O-ring (21) into infrared filter face cap (20).
8. Install Teflon thread tape (item 4, WP0066 00) on threads for mounting infrared filter face cap (20).
9. Install infrared filter face cap (20).
10. Connect cable connector P1 (18) to bottom side of the PWA (13) at J1 (19).
11. Install two diode caps (31) into two holes.
12. Slowly position PWA (13), aligning two sensors on bottom side of PWA (13) into two diode caps (31) in
top body (7).
13. Install three screws (14), three lock washers (15), three flat washers (16), and three nylon spacers (17).
14. Install two screws (10), two split lock washers (11), and two flat washers (12).
15. Solder two connecting wires (8) onto two terminals (9).
16. Verify O-ring (6) is in place in the base (5).
17. Apply silicone adhesive to mating surfaces of base (5) and body (7).
18. Install base (5) using eight hex nuts (3), eight flat washers (4), eight screws (1), and eight flat washers (2).
